Seeding & Tillage

3 Metre Tandem Disc 

Great condition, selling as surplus to requirements. 

3m wide Ripper, no breakout, at 500mm spacing and heavy duty crumble roller. Slight twist in frame but works well.

12m KB Rotacon Leveller

In as new condition, suit new buyer and always shedded.

Linkage Hitch

11000L

3 bin - 2x4700 bins 1x 1600L small seeds bin

Stainless steel hydraulic drive meter units 

Stainless steel bin lids

Load/unload auger 

Wired for Topcon x35 variable rate controller 

Cameras in each bin and on meter units, rear of bin

Lighting on rear and auger

Primary risers and hoses to suit bin

Always washed and shedded when not in use, fantastic condition 

Great accurate bin only selling due to upgrade 

$125,000 ex GST 

12m 2023 Kuhn 50.2H Speed Tiller

Always shedded.

Little work

With trailing flexi roller

Hydraulic roller

6m working width

Inclusion plates

In excellent condition

Always shedded

Mould Board Plough, 13 Furrow Gregoire Besson Reversible Plough, fully hydraulic, trip release, on land machine so an be run with duals, cuts approx 4.2m, suits CAT 3/ CAT 4 linkage, always shedded, have video of working, excellent condition.

22 x Manutec Twin Coulters with 12 inch spacing, that can be adjusted

Armac welding flat rollers 37ft approximately, selling available when new ones arrive

Howard HR30 Rotary Hoe, depth wheels, blades 90%, PTO, 4 speed gearbox, no oil leaks, width 8ft approx, serviced through workshop

Howard Right Hand Rotavator, full offset, 3 point linkage, 42" cut approx

Badalini Rotary Hoe, with new PTO shaft, twin row, 3 point linkage, adjustable width

Berends 5' Slasher, heavy duty, offset, 58 horsepower approximately gearbox, 8" clutch, adjustable skids, refurbished

Berends 4' Slasher, 3 point linkage, new blades, fully refurbished where necessary

16x new bolt on points suit root boot (never used) $55 each

12x used bolt on points suit root included (Free) with new ones

Sold as one

38ft Air seeder case 4300 with 6 Tonne seeder box Horwood Bagshaw 

Brand new Lucerne points and also new motor on seeder box all works and ready to

Use.

The sensors are disconnected but can be connected and used like normal. 

With 3PL homemade end tow drawbar, folds up by a winch and you tow it by end two on the linkage hitch. The roller Is in excellent condition, ready for work. Inspections welcome.

3 sections

12 Meter Precision seeder, 45 openers, 4 inch press wheels, precision seed placement, duel shoot for seed and Fert separation, Sufficient soil throw  to incorporate pre em’s.

It is currently set up for liquids, Agtron seed blockage sensors, has ADF controller to control the down pressures on openers.

All Openers and parallelograms extensively rebuilt before this last season, It will come with a large amount of spares including spare wing tyres and rims, a spare main tyre, a full set of bearings and seals for the press wheels plus much more.

All disc hubs were rebuilt with new seals and bearings before this last season, there are two sets of disc hubs.

It is a very solid bar in very good condition, the bar is weighted to 24ton to allow it to penetrate all soil types, handles high stubble loads

$160,000 + GST.

Circa 1993 Horwood Bagshaw (badged as a HB but built by Simplicity)

7500 Tow Behind Air Seeder Box

approx 7 ton, single shoot, small seeds box 

with 40ft Forward Delta bar, 6 inch spacing, 

Bearings, fan motors and more replaced last time used,

all great working order when parked up.

pallets and boxes of new & used parts, hoses, points, trailing gang assemblies etc 

surplus to requirements, been in shed last 2 seasons, 

cameras to boxes, lighting to box,

all looms, monitors, books etc stored in plastic sealed tub 

2003 Burando Hill liquid fertiliser cart. 7000L tank, 100L hand wash tank, 3" fill, currently running a hydraulic drive PWM John Blue pump (can be converted back to a ground drive John Blue pump).

Cunninghams 40ft Steel Land Rollers

Good Condition - surplus to needs

4x 12 outlet raycol distrbution heads brand new still in box. 75mm inlet and 32mm outlets  $220 including gst each

3x 6 outlet simplicity distribution heads brand new 52mm inlet and 32mm outlets $120 including GST each

5x 12 outlet raycol distribution head used condition 62mm inlet and 25mm outlets $500 including GST the lot

One owner , excellent condition , 15 Hydro Deep Tynes , 5 metre work , 295/80R22-5 tyres . Increase crop yeilds on soils with hardpan problems . Not overwidth for transport.   Ask about Liquid Injection System which can be mounted to this machine . W.A.

Howard Extra Heavy Duty 8' wide Slasher, 3 point linkage

41 foot 

8 3/4 inch spacing

Spring tyne

1" atom jets

Sharman press wheels 

Press wheels have new bearings

Re-pinned and bushed as required

6000L TBH electric drive box

Farmscan controller

Always shedded

Tidy unit

Semeato 4.2m sowing

Double disc seeder

2016 great condition. Shedded. Done little work. 

Spare press wheels about 25 units and steel beams

Most are in reasonable working order

Shearer 5GP

22disc converted with plozza discs. Needs some work to get running again.